Martin Pierce begins his scarab panels by using the sketch shown in the last blog which he traces onto the surface of a paint primed plywood panel.
Using the same sketch Martin traces the body of the beetle onto a 1/8” thick of basswood which is then cut out using a scroll saw. Martin then rounds the edges of the beetle outline using a chisel which he also uses to add lines and indentations to the wing casings which gives the beetle a more 3-dimensional appearance. The beetle is then finely sanded and glued onto the primed panel and clamped in place to form a secure bond. After the beetle is firmly attached any excess glue is scraped away with small chisels.
Using his finger Martin smooths gesso onto the surface and into the pores of the basswood and working with a damp cloth removes any unwanted gesso as he goes.
For the legs and antenna Martin has made a small tool using a short piece of 1/8” round dowel with a chamfered end. The tool is similar in function to a pen quill and fine enough to be used to spread very small beads of thin gesso onto the primed panel to simulate the sections of the beetle’s legs and antennae. Once set any excess gesso is removed with a chisel and then the completed beetle and panel are sanded with very fine 400 grit sandpaper. The panel is then sealed with sanding sealer and is ready to be gilt and glazed.
Insect themes are also used by Martin as cabinet pulls and thumb latches and are central to many of his hardware designs.